Klientų užklausos

M4_Wire_Clip.stl reikia 35 vnt.
M4_Hardware_insert_tight.stl reikia 35 vnt.
Visos kitos dalys po 1 vnt.

Pridedu projektuotojo rekomendacijas.
SUGGESTED PRINT SETTINGS​

If you're 3D-printing your Mark IV yourself, here are the print settings we recommend:

M4_MEDIUM_WHOLE.stl:
- Material: PLA
- Supports: YES
- Raft: hopefully NO (but if supports aren't sticking, try the raft)
- Infill: 20%
- Layer Height: 0.2mm
- Number of Shells: 3
- Speed while extruding: 50-70% (slow it down if possible; these parts are detailed)

M4_Hardware_insert_tight.stl, M4_Wire_clip.stl:​
- Material: PLA
- Supports: NO
- Raft: NO
- Infill: 20%
- Layer Height: 0.2mm
- Number of Shells: 3
- Speed while extruding: 50-70% (slow it down if possible; these parts are detailed)

M4_BOARD_MOUNT.stl, M4_BOARD_COVER​_updated.stl:
- Material: PLA
- Supports: NO
- Raft: NO
- Infill: 20%
- Layer Height: 0.2mm
- Number of Shells: 3
- Speed while extruding: 50-70% (slow it down if possible; these parts are detailed)

ADDITIONAL TIPS FOR A SUCCESSFUL PRINT​

The Ultracortex frame is detailed and can be challenging to print, so we strongly recommended that the operator be experienced enough to determine how settings need to be changed for their machine. That being said, here are some good general tips:

Print a tall test model such as a figurine with overhanging features (limbs) to ensure your machine is working properly.
Don't use too much support. Default settings in CURA usually work, but Prusa is heavy on support and makes the headset hard to remove without breaking.
Print the headset in two halves with the flat sides on the printer bed, as mentioned previously in this document. Use a brim around the edges if your printer has peeling problems. The brim takes extra work to remove but increases likelihood of success. The parts are designed to print at this orientation with least support.
Here are other tips in order of importance.
Print slowly, about 50% of default speed, and run the extrusion hotter than normal. 220 degrees is recommended.
Print using a support raft.
Print in a warm environment to reduce the shrinkage of the part as it cools.
Use PLA material (not ABS) and a heated bed.

Sveiki,
ieškau, kas galėtų kokybiškai (nereikia idealiai, nes suprantu, kad kaina nuo to kyla) atspausdintų rėmelius (prisegtuke daugiau detalių). Pažymėtina, kad raudona linija yra storis, kuris svyruoja nuo 1cm iki 3cm (nors ten parašyta iki 5cm). Kiekis tikslinamas, bet preilimanariai 23vnt.
1cm x 12vnt.
2cm x 6vnt.
3cm x 5vnt.
Matmenys, storiai gali būti koreguojami, jei kaina ženkliai mažėtų.
Sienutė / nugarėlė (rėmelio) apie 2mm storio.
Labai svarbu tilpti į terminą. Prioritetas plastikui PLA. Spalva balta. Jei kainos nekeičia reikėtų ir dviejų tonų skirtingų pilkų spalvų, ne vien baltos.
Lauksiu žinių.